![]() Glue/screw it to the deck, and make your enclosure go over them. Cut out the deck so the flat side sits in it flush. This other way is easier, but meh… becuse 90° Sides… To remove or install the lid, unscrew it, remove the front truck and slide it in/out. Use T-nuts or sex bolts to attach it to the stingers. These^^ are visible (on the outside) when your enclosure is installed. Then after test fitting, mix up the resin and insert your Aluminum strips or flat stock carbon, or the glass/Kevlar or whtever flat stock you made and prefer. Set the depth at around 3/8"/10mm, and cut a channel out of the deck on each side.īut wait!! You need to hot glue a guide to the deck to make it acurate, as well as practice on some scrap unless you’re very competent with a skilsaw… But wait!!! You might want use a thin kerf blade. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |